For this demonstration we are using a Playseat and a 1×6” (19×140 mm) plank with a T-Nut (You can also use the uni-mount bracket or other TST mounting forms)
Mounting a Transducer in a Gaming Chair
-
Flip the seat over
-
Mark two holes 3” (7.6 cm) apart on both sides under the seat
-
Drill the marked holes
-
Cut a 1×6” (19x140mm) wood plank to the seat width
-
Mark two holes 3” (7.6 cm) apart on both ends
-
Verify the markings line up with the holes drilled in the seat
-
Drill the marked holes
-
Measure and mark the center of the plank
-
Drill a 7/16” (11 mm) hole
-
The plank will look like this
-
Hammer the T-Nut into the center hole
-
Place the plank under the seat with the T-Nut facing down
-
Tighten all 4 screws
-
Screw the short-threaded stud into the T-Nut
-
Place a flat washer and a lock washer onto the stud
-
Screw on a lock nut and tighten with a 9/16” wrench
-
Screw on a second lock nut, but do not tighten it
-
Carefully screw the Transducer onto the stud
ONLY TIGHTEN THE TRANSDUCER USING TOOLS!!! -
Use two 9/16” wrenches to tighten the lock nut against the brass nut
-
Flip the chair over. Make sure the Transducer does not touch the floor
Enjoy your best gaming experience yet!
For more information contact Clark Synthesis
303-797-7500